CBI60W

The new line of DC-UPS with Ethernet interface consists of following models: CBI6012A (12V 5A), CBI6024 (24V 2.5A) and CBI6048A (48V 1.25A) with 1-phase AC input (90-305VAC); CBI60024A (24V 25A) and CBI60048A (48V 12.5A).

They use switching technology with microcontrollers and optimize battery charging and discharging time without deep discharge, switching from battery to charger without any interruption, automatic fuse-free protection against backup polarity, short circuit and overload, and overvoltage.

The CBI60W and CBI600W series have different charging profiles for lead-acid, AGM, GEL, NiCd, NiMh, Li-Ion and LiFePO4 battery technologies.

The CBI60W series with integrated Ethernet SNMP, Modbus TCP/IP and HTTPS protocols is the new DC-UPS All In One module with output voltages of 12V, 24V or 48V. The module design follows the same reliable performance as the current line of CBI All In One DC-UPSs. The CBI60W All In One series consists of:

Power Supplies
Backup Module
Battery Chargers
Battery Tester

The CBI60W series has always been based on Adelsystem's Battery Care technology:

Battery-specific charging profiles (lead acid, AGM, GEL, NiCd, NiMh, Li-Ion and LiFePO4);
Charge temperature compensation;
Deep discharge protection;
Charging current limiter;
Battery tester (battery connection, polarity reversal, shorted cells, bad internal impedance);
Battery health monitoring

The interface allows you to:

Monitor parameters;
Configure parameters;
Record data and events;
Receive alarm notifications For example, the operator can monitor the following parameters:
AC input voltage;
DC output load voltage, current, power and output status;
Voltage, current and internal resistance of the battery
Receive alarms on network, device and battery faults.

Based on the data received, the user can improve system efficiency and better optimize system power consumption.

Load output and relay configuration

The load output is fully configurable, and the CBI60W series allows the user to enable and disable the load output according to the type of application.

Turn off the load via a command via webserver or external button
Turn on the load as soon as the AC grid fails (emergency lighting)
Power the load for a specific period of time
Powering the load for cyclic operation, the load turns off and on cyclically and autonomously according to configured timings
Ability to connect load activation to an external push button